Royal Kote
UV-Inhibited Sealer
Item Numbers: 48001, 48005, 48055
U.S. Department Of Labor
Occupational Safety And
Health Administration
MATERIAL
SAFETY DATA SHEET
Required Under USDL
Safety And Health Regulations
(29 CFP 1910.1200
"Hazards Communication Standard")
Section I
Manufactured For: Gabriel First Corp.
Emergency Telephone: 1-800-424-9300
Address: 233 W. Commercial Street, East Rochester,
NY 14445
Trade Name & Synonyms: Royal Kote Sealer/Finish
Prepared On: 02/01/2005
HMIS
RATING
HEALTH FLAMMABILITY REACTIVITY SPEC HAZARD
2 1 0 -
Section II -
Product & Component Data
Chemical Names CAS
Registry No % TWA
Dibutyl Phthalate 84-74-2 1-5% 5mg/m3 TWA
Butyl Carbitol 112-34-5 5% NE
All components of this product are in compliance with U.S. TSCA chemical substance inventory requirements.
Section III - Physical Data
Boiling Point: 212°F (100° C)
Specific Gravity (H2O=1): 1.01
Vapor Pressure: 24 mmHG @ 298° F.
Vapor Density (Air=1): 9.6
Evaporation Rate: .4
Solubility In Water: Soluble.
Density (weight per gallon): 8.476
Physical State: Liquid.
Odor: Normal for this product.
pH: Not determined.
Section IV - Fire And Explosion Hazard Data
Flash Point TCC/PM DEG F: 201° F
Lower Explosive Limit: Not Available
Upper Explosive Limit: Not Available
Special Fire Fighting Procedures: Fire fighters must wear self contained breathing apparatus or air masks. Containers exposed to fire should be kept cool with water spray.
Extinguishing Media: In case of fire, use carbon dioxide, dry chemical or alcohol foam. Water spray, used with care, may be used to keep containers cool. Water spray can cause frothing above the boiling point of water.
Unusual Fire and Explosive Hazards: Closed containers may explode due to build up of pressure when exposed to heat.
Section V - Health Hazard Data
Effects Of Overexposure:
Immediate Effects (Acute): Harmful if inhaled. May affect the brain, nervous system or respiratory system, causing dizziness, headache, nausea or respiratory irritation. Overexposure to ingredients in this product may cause irritation of the gastrointestinal tract, nose and throat irritation, eye irritation, and skin irritation.
Delayed Effects (Chronic): Reports have associated repeated and prolonged occupational overexposure to solvents with permanent brain and nervous system damage. Intentional misuse by deliberately concentrating and inhaling the contents may be harmful or fatal. May cause liver damage. May cause effects to the blood and blood system. Possible birth defects hazard. Contains ingredients which may cause birth defects based on animal data. May cause kidney damage.
Other Conditions Generally Aggravated by Exposure: Any respiratory or skin condition.
Emergency First Aid Procedures:
Eyes: Flush immediately with water for at least 15 minutes. Call a physician.
Skin: Wash affected area ASAP with soap & water.
Inhalation: Remove subject to fresh air. Call a physician.
Clothing: Remove contaminated clothing and shoes. Thoroughly clean contaminated shoes and clothing before reuse.
Ingestion: Get medical attention immediately.
Section VI - Reactivity Data
Stability Conditions To Avoid: Stable
Incompatibility: Avoid water-reactive material, heat or contact with peroxides or other catalysts.
Hazardous Decomposition Products: Carbon Dioxide/Monoxide
Hazardous Polymerization Conditions To Avoid: Will not occur.
Section VII - Spill Or Leak Procedures
Action to be taken if Material is released or spilled: Ventilate area. Avoid breathing vapors. Use self-containing breathing apparatus or air mask for large spills in a confined space. Eliminate ignition source(s). Remove with inert absorbent and non-sparking tools. Avoid contact with eyes.
Waste Disposal Method: Dispose in chemical disposal area or in a manner that complies with local, state and federal regulations. Do not incinerate closed containers.
Section VIII - Special Protection Information
Respiratory Protection (Type): If the product is sprayed, respiratory equipment should be used. Unless air monitoring demonstrates vapor/mist levels above applicable limits, no respirator is required. If respirator is required, the appropriate, properly fitted respirator (NIOSH approved) should be worn during application. Follow respirator manufacturers directions for respirator use.
Ventilation: Required when spraying or applying in confined area.
Protective Clothing: Avoid contact with eyes. Wear chemical goggles if there is the possibility of contact or splashing in the eyes. Avoid prolonged or repeated contact with skin. Wear chemical resistant gloves and other clothing to keep exposure to a minimum. Cover arms and legs. Contact lenses should not be worn when working with chemicals because contact lenses may contribute to the severity of an eye injury in case of exposure.
Section IX - Special Precautions
Precautions To Be Taken In Handling And Storing: Keep away from heat, sparks and open flames. Keep container closed when not in use. Do not store above 120 degrees F based on the product flash point and vapor pressure suitable storage should be provided in accordance with OSHA regulation 1910. 106. Empty containers may contain product residue, including flammable or explosive vapors. Do not cut, puncture or weld on or near container. All label warnings must be observed until the container has been cleaned or reconditioned.
This
information is given in good faith, but no warranty expressed or implied is
made. Our company believes that it is
accurate to the best of its knowledge and relates only to the specific material
designated herein.