Vandal II Mark Remover

Item Number: 2660-0926

 

U.S. Department Of Labor

Occupational Safety And Health Administration

MATERIAL SAFETY DATA SHEET

Required Under USDL Safety And Health Regulations

(29 CFP 1910.1200 "Hazards Communication Standard")

 

Section I

Manufactured For:  Gabriel First Corp.

Emergency Telephone:  1-800-424-9300

Address:  233 W Commercial Street  East Rochester, NY   14445

Trade Name & Synonyms: Vandal Mark Remover II

Prepared On:  05/02/2005

Proper Shipping Name: Vandal Mark Remover II

 

Section II - Product & Component Data

Component(s)/ Chemical Names                                      CAS Registry No.                             %                 TLV                PEL

Toluene                                                                                          108-88-3                                       15                    50                   200

Methylene Chloride                                                                      75-09-2                                        43                    50                   500

Perchloroethylene                                                                        127-18-4                                       10                    50                   100

Nonylphenol Ethoxylate                                                             9016-45-9                                     1.5                   NE                   NE

Liquified Petroleum Gas                                                             68476-85-7                                  25-30               1000                1000

 

Section III - Physical Data

Boiling Point: NA

Specific Gravity (H₂O=1): <1

Vapor Pressure: 90@130F

Percent, Volatile By Volume(%):

Vapor Density(Air=1):  >1

Evaporation Rate: <1

Solubility In Water: Negligible

Appearance And Odor: Heavy, course wet spray, strong methylene chloride and toluene odor.

 

Section IV - Fire And Explosion Hazard Data

Special Fire Fighting Procedures: Containers should be cooled with water to prevent vapor pressure build up.

Flash Point/Method Used:

Flammable Limits: LEL:  1.8    UEL: 9.2

Extinguishing Media: CO2, Dry Chemical or Foam.

Unusual Fire And Explosion Hazards: At elevated temperatures (over 54C-130F) containers exposed to direct flame or heat should be cooled with water to prevent weaking of container structure.

 

Section V - Health Hazard Data

Effects Of Overexposure: Inhalation is the primary route of exposure and may cause dizziness, drowsiness, and throat irritation. Prolonged or repeated skin contact can cause irritation and defatting of skin. Chronic exposure to methylene chloride and perchloroethylene has caused liver toxic in experimental animals.

Medical Conditions Aggravated By Exposure: Preexisting skin or eye disorders may be aggravated by exposure to this product. Acute and chronic liver disease and rhythm disorders of the heart.

 

Emergency First Aid Procedures:

Eyes: Flush eyes with water for 15 minutes. If irritation persists, get medical help.

Skin: Remove contaminated clothing. Wash with soap and water.

Inhalation: Remove victim to fresh air.  Give CPR if not breathing. Get medical help.

Ingestion: Get medical help.

Note to physician: Adrenaline should never be given to persons overexposed to this product.

 

Section VI - Reactivity Data

Stability                 Conditions To Avoid

Stable                    

Materials To Avoid:  Oxidizing agents, heat and open flame.

Hazardous Decomposition Products: Carbon monoxide, carbon dioxide, hydrogen chloride, phosgene and additional toxic chemicals may be formed in small amounts.

Hazardous Polymerization                        Conditions To Avoid

NA               Do not store above 54C-130F. Keep away from heat, direct sunlight, open flame or sparks.  Dropping of container may cause bursting.

 

Section VII - Spill Or Leak Procedures

Steps To Be Taken In Case Material Is Released Or Spilled:  Remove all sources of ignition and ventilate area. Soak up spill with an inert absorbent and place into a designated disposal container.

Waste Disposal Method: Do not puncture or incinerate. When contents are depleted, depress button until all gas is expelled and dispose of container in accordance to local, state, and federal regulations.

 

Section VIII - Special Protection Information

Ventilation: Local Exhaust.

Protective Gloves: Chemical resistant.

Eye Protection: Chemical safety glasses.

Other Protective Equipment: Wear impervious clothing.

 

Section IX - Special Precautions

Precautions To Be Taken In Handling And Storing: Avoid breathing vapor. Keep away from heat or open flame. Use with adequate ventilation. Do not expose contents to temperatures above 54C-130F. Do not puncture or incinerate.

Other Precautions: Please read entire label before using, it is your best guide to using the product in its most effective manner.

 

SUPPLIER NOTIFICATION UNDER SECTION 313 OF SARA: Pursuant to Title III of the Superfund Amendments and Reauthorization Act of 1986(SARA) and  40 CFR Part 372, our PRODUCT: VANDEL II MARK REMOVER contains toxic chemicals in quantities subject to the reporting requirements under Section 313(See Below).  Effective January 1, 1989, any person who sells or otherwise distributes a mixture or trade name product containing toxic chemicals must provide written notice to the recipient with the first shipment in each calendar year.  If the recipient repackages or otherwise redistributes this product a notice indicating that this product is subject to the reporting requirements of Section 313, including the reporting chemical name/category, CAS number and percent by weight, must accompany the shipment.  Please note that the notification letter must be attached and remain attached to the Material Safety Data Sheet.

Chemical Name:                                      Case Number                           % By Wt

Toluene                                                          108-88-3                                       15

Methylene Chloride                                      75-09-2                                       43

Perchloroethylene                                        127-18-4                                       10

 

 

This information is given in good faith, but no warranty expressed or implied is made. Our company believes that it is accurate to the best of its knowledge and relates only to the specific material designated herein.